Crate TX50DE Especificaciones

Driver’s Guidefor theCRATE LIMObattery powered amplifierwith the new rugged, lightweight molded polymer enclosure!

CRATE10SUGGESTED SET-UPS (continued):Idea 3 – Sing along: Connect a low impedance microphone to the Low Zjack. Connect a high impedance microphone to

CRATE11SYSTEM BLOCK DIAGRAM:INSTRUMENTCHANNELMICCHANNELCDINPUTSLOW MID HIGHGAINLEVEL12CHANNELSELECTLEVELDSPSENDTONESLOW MID HIGHTONESSHAPEDCCHARGERCHA

©2001 SLM Electronics • A division of St. Louis Music1400 Ferguson Avenue • St. Louis, MO 63133P/N 47-099-02 • 08/01CRATETECHNICAL SPECIFICATIONSOUTPU

CRATECONGRATULATIONS!You are now the proud owner of the Crate TX50DE battery powered ampli-fier with Digital Signal Processing. At last, you can take

CRATE3FEATURES:• Two separate channels• Crate’s Digital Signal Processing (DSP)• Insert jack for connecting external effects• CD Inputs for connecting

CRATE4ABOUTTHE POWER SUPPLY:The TX50DE uses a sealed lead-acid 12-volt battery as its internalpower source. Unlike ni-cad batteries, this battery has

CRATE5ABOUTTHE POWER SUPPLY (continued):The TX50DE may also be powered by using a 12-volt vehicle cigarettelighter adapter, available at most electron

CRATE6THEFRONT PANEL:1. LOW Z: Connect a low impedance micro-phone here by means of a shielded signal cableterminated with an XLR type connector.2. HI

CRATE714. LOW (Active only when the Channel Selectswitch is in the out position): Use this control toadjust the low frequency level for the instru-men

CRATE8YPP117DUAL MONO 1/4" TOSTEREO 1/4" ADAPTERSTEREO 1/4" TOSTEREO 1/4" CABLETOINSERTJACKTOSTANDARDINSERTJACK OFEFFECT(IF EFFECT

CRATE9SUGGESTED SET-UPS:The TX50DE can be used in a variety of different ways, some of whichare shown below and on the following page. Use these ideas